Brainwave Entrainment, Sleep Induction and Accelerated Learning
(Click on photo for a larger version)
Dual Wand/Antenna Receive
With the VRCR off, plug both Crystal Wands into the High Voltage output using the
“Piggy Back” cable, and the Pyramid Antenna into the Low Voltage Output.
The function of the Pyramid antenna in this mode is primarily to receive subtle higher energies. The Pyramid Antenna always transmits and receives no matter what output it is plugged into, but its focus or main purpose changes dependant upon the configuration.
Methods:
Sleep Induction:
When using the VRCR for Sleep treatment and enancement of the dreaming state, one to two people can place a Crystal Wand under each pillow when sleeping. Simply choose the Frequency of an Energy Canter that best represents the qualities you would like to focus upon. Setting the VRCR to EARTH CENTER-RED, the lowest of the 16 VRCR settings at approximately 3.92Hz, will promote the "Theta State” by slowing brain waves down for creative dreaming. If not asleep within 10 minutes, setting the VRCR to Red (0) will produce an approximate 2 Hz. Frequency to take you into to deep, deep sleep. While this setting is not an harmonic of the Schumann Frequency, it has been found to be very effective.
Optimizing Natural Brain Function:
By placing a Crystal Wand for a minimum of 3 minutes at each setting you desire to tune with at the base of the brain (hypothalmus) and behind the head Center (Zeal), we can properly tune the Medulla Oblongata to enhance its natural processes that influence the rest of the brain and our mental and physical health.
For list of settings please go here, to our Low Frequency Brainwaves chart (.pdf).
Accelerated Learning and Increased Retention:
For optimum effect, find a way to place the Wand to the “Zeal Center” at the base of the brain (hypothalmus). You can rest it on a pillow, top of a chair-back or make yourself a "necklace" that will hold the Wand at your back. Be innovative. Another option would be to use the Pyramid Antenna instead of the Wand and hang behind the head or in close proximity for maximum affect. Just having the Pyramid in the room also works but closer is better.
Then follow the following protocol:
-
To start, set VRCR to LIFE CENTER-RED, at 7.83Hz. This will promote an “Alpha State” relaxation.
-
After a minute or two, change the setting to ELIMINATION CENTER–RED, at 15.66Hz for one minute. This will promote a “Beta State”.
-
Then switch to STRENGTH CENTER-RED at 31.32Hz for one minute, promoting a “High Beta State.”
-
When done, switch back to ELIMINATION CENTER-RED, for one minute.
-
Finally, switch back to LIFE CENTER-RED, for at least three minutes.
Select a frequency from the Low Frequency Brainwaves chart (here) that is focused on accelerated learning, such as the “Strength” Center setting of 31.22Hz. Then, either hold the High Voltage Wand with your hand or hold it hands free and place on the Zeal Center behind the Hypothalamus. And that's it! Perform your task (i.e. read, study, practice, etc.)
To VRCR - Operating Modes
Main Page
|
